Compatible Parts
Frame | Notes |
---|---|
Headset bearings | Lower bearing 56.8 mm OD x 48.8 mm ID x 6.5 mm x 45° Upper bearing 45.8 mm OD x 36.8 mm ID x 6.5 mm x 45° |
Headset collar | See manual for headset adjustment instructions |
Seat post/clamp | D-shaped aero seatpost: 380 mm for sizes 44-58; 450 mm for sizes 61 & 64 Seatpost wedge |
Axles | Front 12 x 100 mm Rear 12 x 142 mm |
Brake Rotor Min/max | Front 160 / 180 Rear 160 / 160 |
Fork | Size-specific fork as specified in service parts list |
Drivetrain | |
Chainring min/max | Single ring: 31t-50t Double: inner 31-34; outer 48-50 |
Front derailleur | 1x or 2x (removable hanger) |
Rear derailleur hanger | S182600001 |
Bottom bracket | 68 mm BSA threaded |
Wheels | |
Tires | 28-38 mm Space between tire and front derailleur is limited when using a 700 x 35c tire or larger. It is recommended to use either a SRAM Wide crankset and front derailleur, or a Shimano GRX crankset and front derailleur, or a 1x front chain ring for these tire sizes. |
Tubeless compatibility | Rims on all models are tubeless compatible; tires on Base are not compatible |
Accessories | |
Water bottle mounts | 4: top tube, seat tube, down tube, underneath down tube |
Racks | Not compatible |
Fenders | Fender mounts included, see below Compatible with 35mm Dry-Tech fenders (note this will reduce max tire size to 35 mm) |
Kickstand | Not compatible |
Fender Installation Instructions
Rear Fender
Attaching a rear fender to your bicycle requires an upper or lower fender mount attached to the seat tube. The size of your frame determines which fender mount your bicycle requires.
Sizes 44, 49, 53 use the upper mount (A) and sizes 54, 56, 58, 61, 64 use the lower mount (B)
- Select the correct mounting clamp for your size frame (A) or (B).
- Open the mounting clamp (A) or (B) and place it on the seat tube above or below the seatstay according to the size of your frame.
- Insert the bolt (C) into the mounting clamp, then use a 4 mm hex key to gently tighten the bolt.
- Assemble the fender (D) onto the fender mount, then adjust the position of the mount to fit the fender position. Using a torque wrench and 4 mm hex bit, torque the mount bolt (C) to specification stated on the clamp.
- Behind the bottom bracket (E) and at the rear dropouts (F), there are M5 and M4 threaded frame inserts that can be used for mounting fender stays. Install the fender according to the manufacturer's instructions.
Front Fender
- The fork dropouts (A) and behind the fork crown (B) have M5 threaded frame inserts that can be used for mounting fender stays. Install the fender according to the manufacturer's instructions.