Installation Tips
- Ensure both your rim and tire are tubeless compatible before proceeding
- Inspect the rim for dents or cracks and check rim plugs or rim tape to ensure a good seal
- Remove any old sealant
- Install tubeless valve stems and tighten the nut by hand to snug the valve to the rim
- Install the tire by hand with the rotation arrow pointing in the correct direction
- Add sealant
--Install both sides of the tire if you will add sealant through the valve stem
--Leave a gap on one side of the tire if you will add sealant directly inside the tire; rotate the tire after adding sealant to finish installing the tire without spilling sealant - Check that the tire bead is centered on the rim
- Inflate the tire to the maximum pressure listed on the rim or tire (choose the lower maximum) and ride your bike for 5 minutes to set the tire
- Reduce tire pressure to your preferred riding pressure
Check and refresh sealant every 8-16 weeks to maintain optimal performance
The following video shows installation of RapidAir road tubeless sealant, but the process is the same for 2Bliss sealant as well: